nutsgoweee
About
- Username
- nutsgoweee
- Joined
- Visits
- 3
- Last Active
- Roles
- Member
Comments
-
Okay thank you. I used a ruler and 200mm of commanded travel to get a correction factor of 1.435 (with the x2 already applied) so I am using 229.67 steps per mm and it's making parts very accurately now (measured 19.94 x 19.80 x 19.98 for a 20mm c…
-
I should add that I'm not falling for the EEPROM trap - I can change the steps per mm with repetier host and that changes the distance moved. Perhaps I need to increase my STEPPER_HIGH_DELAY to 2? Could that have any affect? Changing it to 1 fixe…
-
I have doubled, halfed, and quadrupled my steps per mm (160 for 1/16th stepping) but the problem is that it moves 70mm for every 100mm when set properly (doubled). Doubling the steps again makes it move 140mm for every 100mm. I've checked and re-ch…
-
When homing, I know after the first time the switch is hit, the axis backs up and hits again slower to be more accurate. My Z-homing speed from the beginning default settings was very slow. It might be homing too slow and the reduction is too much…
-
Also wanting this, I have a VIKI 2 LCD and cannot use it