minhnghia
About
- Username
- minhnghia
- Joined
- Visits
- 2
- Last Active
- Roles
- Member
Comments
-
my printer is delta. HRR is Horizontal rod radius. and I do it myself so i havent have instructions how to do this
-
After following your suggestions. I was able to fix it. Thank you very much
-
Repetier said: After homing check position with M114. My guess is that z length is much too high so z=0 is below bed level. Start with G1 Zxxx where xxx is some mm lower tAfter following your suggestions. I was able to fix it. Thank you very …
-
Oh, sorry! My printer is delta type. I use repetier fw, arduino mega and ramp 1.4. All my endstop at max position