melvinbrucepaton
About
- Username
- melvinbrucepaton
- Joined
- Visits
- 5
- Last Active
- Roles
- Member
Comments
-
Problem resolved, turns out i needed to add the enable wire from the ramps 1.4 to the DQ542ma"s as well as enable the the enable xyz in config h.
-
And if I go into manual mode and try to adjust the position, the stepper motors dont do anything. So anybody has any clue what I'm missing (And please remind Im a total beginner in this 3D printing software) I had to turn off all my hard ware end…
-
Hi Remko i am busy with the same project, i am a little further than you once you have uploaded the firm ware to the arduino board, open the repetier software then set you printer settings to the correct coms port. and board rate then click connec…
-
I should mention i have copyed this build http://www.instructables.com/id/Arduino-Controlled-CNC-3D-Printer/