mbgm_mbgm

Comments

• Sounds good, I'll look for those. Thanks!

  in Objects are placed below the print bed Comment by mbgm_mbgm May 2019
• Thanks for your help and patience! So for very small objects, I should just make them 1.27 mm higher?

  in Objects are placed below the print bed Comment by mbgm_mbgm April 2019
• The forum won't let me post an STL file directly, but here is the code for a simple box which exhibits the problem: solid box testfacet normal 0.0 0.0 -1.0  outer loop    vertex 2.54 2.54 0.0    vertex 0.0 0.0 0.0    vertex 0.0 2.54 0.0  endloopend…

  in Objects are placed below the print bed Comment by mbgm_mbgm April 2019
• Sure, I'll send it tonight. Just the STL file or the Sketchup file as well?

  in Objects are placed below the print bed Comment by mbgm_mbgm April 2019
• Yes, if I rotate the view to below the object, I see the lower section is bright blue and the top section is darkened by the bed. If I zoom inside an object, I can see the bed surface cut through the bottom of the object. I only noticed it because…

  in Objects are placed below the print bed Comment by mbgm_mbgm April 2019