markmark10
About
- Username
- markmark10
- Joined
- Visits
- 5
- Last Active
- Roles
- Member
Comments
-
Got it working, changed to E1, so wiring connector to motor, driver all over to E1 and then just changed the pin numbers in pins.h, swapped the numbers between e0 and e1.
-
Just updated firmy to 0.92.5, uploaded, connected and still no luck. Going to catch some z's and try again later
-
Can't edit the above: "continues to do nothing when told to" not anything
-
Repetier, thanks for commenting. You were right about the invert enable. Toggling that between 0 and 1 was one of the things I was using to debug, so the 1 setting was still on the eeprom when I was describing the symptom of the motor being "on". On…
-
Thanks!!! I did try toggling the invert setting, but I'll have another crack. Will report findings ASAP
-
Okay so when I connect to rep, the motor squeals, heats up and also locks up (I can't turn it by hand). It's pulling between like 0.5 and 2.5 V across a pair of "windings" I guess you could say, maybe phase is the better term. So even though I haven…
-
Extruder motor is hot!!! Perhaps it's getting a signal after all.... Driver pot setting???
-
Additional info: Using Marlin, Repetier (obvs) RAMPS 1.4 all the standard stuff. The fan isn't hooked up yet (is there a "fan must be on to extrude" setting?) Similarly, disabled hotbed just cuz I don't want to wait for it to heat before each trial …