laurent
About
- Username
- laurent
- Joined
- Visits
- 4
- Last Active
- Roles
- Member
Comments
-
When I test TTL, I've erased M3 code
-
I've tried to connect TTL (on D51 on my MKS Base) and PWM on 12V, but in this case, laser is always "on".
-
And in this config, I'm still connect on pin bed 12V to pilot on/off
-
Ok In fact when I use manual code with M3/M5 it's ok, just like this one: G0 X150 Y125 M3 S200 G1 X200 G1 Y175 G1 X150 G1 Y125 M5 But as soon I use auto gcode done by repetier it flash as I sayd before.So I've tryed to add that in custom Gcode "aft…
-
If I use a manual gcode with M3/M5 it seems to work perfectly. But I 've change retraction to 0 and extruder at 0,2 but nothing change. The only thing I' ve tried yet is to use 5v pin, but I don't understand where connect it and how use it?
-
Yes is what I use M3/M5
-
My laser is working with electronic card and 2 inputs (PWM 12v and TTL 5v)
-
Sorry but What do you call "E"?
-
Sorry but What do you call "E"?
-
Do you think that if I use TTL, it would be more precise, and laser would be activated faster?
-
OK, thank you, I've any modifications: I use Laser mode, Laser still connect to heat bed PIN, Do not use TTL, just on/off by 12V it's ok with G0 and G1, laser stop and start when necessary. I've put 1000 ms for laser warmup time. But I've still …
-
If I enter G code M104 S255, it's better, but some flash (when it change of way), but it's better
-
M42 can be used for any pin, but it needs to be declare?
-
the seller say that it can be use with PWM 12V... Which connexion should I use please?
-
M42 can be used for any pin, but it needs to be declare?
-
You say that I need to use ttl?