kaworu
About
- Username
- kaworu
- Joined
- Visits
- 19
- Last Active
- Roles
- Member
Comments
-
Direct connected buttons would be better, but since I have 8 buttons, encoder, 7 LEDs and one display driven by parallel bus - 8 signal pins available on Melzi aux connector may be not enough. So I've thought about integrating all of them into one m…
-
Sure I do, https://www.dropbox.com/s/xr0jt0j92lcxwmx/Repetier-Firmware-5keys.rar?dl=0 changes are described in modiefied.txt And one more question, how safe is using interrupt driven keypads? I was thinking about creating yet another controller mod…
-
Well, like I've said - I don't know how repetier exactly works. I would vote for ignoring mechanical probes all together for this function. So, few words of warning should be added to documentation/configurator (if it will be integrated). People wh…
-
Herc001: I also have mk2b, but mine is apparently faulty. Anyway, check https://www.dropbox.com/s/lcq45ae2g2dahdo/firmware.zip?dl=0 ? I don't remember from where I got it, but binary images from this package worked well. I didn't check sources, beca…
-
> This is rep..5keys.rar is working all? or only configured keys? I have the same model (v1.4/black), and ...5keys.rar works fine. Unfortunately I couldn't bacup original firmware, since bootloader is not installed on my board and flash lockbits…
-
I've took liberty of writing code for Z-Homing using z-probe. But since I have no idea how internals of FV work, this code can be buggy, or some important aspects could be omitted. It does however work for me. It should be added at the beginning of …
-
M114 after second homing gives: Recv: X:0.00 Y:0.00 Z:0.000 E:0.0000But I've noticed something more, if printer is in absolute coordinates mode G1 Z1 F100 works as expected, if I switch printer to relative mode (G91), then nozzle is raised to (orig…