karl_ranseier
About
- Username
- karl_ranseier
- Joined
- Visits
- 18
- Last Active
- Roles
- Member
Comments
-
Repetier said: Before servo was off, afterwards it is holding position with force. - M340 P S R: servoID = 0..3, Servos are controlled by a pulse with normally between 500 and 2500 with 1500ms in center position. 0 turns serv…
-
No, it has not. Could this explain, why it occurs only after the Auto bed levelling? Position of servo is the same before and after auto bed levelling.
-
I found out: If I disconnect the servo, I do not have the oscillations. The oscillations depend on the value of the servo. M340 P0 S2265 produces high oscillations (but only after bed levelling!). M340 P0 S1865 produces nearly no oscillations. Stil…