› ›

jstevewhite

About

Username
jstevewhite
Joined
Visits
4
Last Active
Roles
Member

Comments

  • Thanks. I went back to the same configuration I have been using with 92.6, without trying to use distortion probing; just three-point probing for bed slightly unlevel again. I have a dual-stepper Z drive and when the power is turned off they will dr…
    in Z-Probe problems after upgrade to 92.8 Comment by jstevewhite February 2016
  • Ok, after reading the comments (thanks!), I changed my Z probe configuration such: #define Z_PROBE_Z_OFFSET 0#define Z_PROBE_Z_OFFSET_MODE 0#define UI_BED_COATING 1#define FEATURE_Z_PROBE 1#define Z_PROBE_BED_DISTANCE 35#define Z_PROBE_PIN 63#define…
    in Z-Probe problems after upgrade to 92.8 Comment by jstevewhite February 2016
  • If I put the servo command in the Z-Probe start script, will it also move the bed to z probe height + max z probe distance, or do I need to do that first? I'm assuming I need to move the probe over the bed, move the bed down out of the way, and swin…
    in Z-Probe problems after upgrade to 92.8 Comment by jstevewhite February 2016