jonbondy
About
- Username
- jonbondy
- Joined
- Visits
- 10
- Last Active
- Roles
- Member
Comments
-
So. No suggestions?
-
I am using the CuraEngine that is part of Repetier Host.
-
There is only one extruder profile defined, and it is correctly selected. It specifies 200 C while the emitted GCode shows 210 C.
-
Thank you. Not sure what the "right side" is. I note that, as I said before, the Filament, Print Temperature is 200. I don't see "General" anywhere. I open the Slice tab and click on the Configuration button and then go to the Filament tab to se…
-
As I said, originally, the CuraEngine Filament Print Temperature is 200, and yet the extruder temperature is set to 210 when a print starts. You are correct that the temperature shown in the GCode is 210. But I never specified that temperature any…