jomo
About
- Username
- jomo
- Joined
- Visits
- 3
- Last Active
- Roles
- Member
Comments
-
Thank you But why does the Z coor show 0 correction?
-
My mistake, Definitely using Repetier firmware. So G29 started working OK (is it possible that changes in Eeprom don't take effect immediately?). But now, G32 traces a path parallel to X and Z towers until it falls off the bed. It seems I can only…
-
OH WOW, after reviewing your comment , I just realized that the print configuration pull down on the left side of host had disappeared until I stretched out that window. I had forgotten that that was there for years ha ha.
-
OK, Figured it out. It seems 2.2.2 does not like comments in the script using //. I removed them and everything is back to normal.
-
Ha Ha all these years and I never saw that Thank you!
-
Thanks for your reply martinh The G29 is 3 point level and does work in Repetier 1.0.2 G32 is multiple points. It is now working for me. It looks like you must run g29 or G32 after you change Zprobe height. I assumed that you could just change …