jmarasch

About

Username: jmarasch
Joined: September 2014
Visits: 19
Last Active: February 2015
Roles: Member

Comments

Yes, it appears to be the led on pin13.

in Extruder 1 and RAMPS 1.4 Issues Comment by jmarasch September 2014
Thanks a million that did the trick. never even noticed that option. The second extruder heats up properly now however my blue communication light turns on until the initial heat up is done. should i be concerned about that?

in Extruder 1 and RAMPS 1.4 Issues Comment by jmarasch September 2014