› ›

jkret

About

Username
jkret
Joined
Visits
2
Last Active
Roles
Member

Comments

  • I have tested it on my machine and it works.Thanks
    in Host fails to connect to Windows Comment by jkret April 2022
  • Thanks for the tip.Solution: Set in the CamBam system at the postprocessor the minmal arc length to 0.001 (before 0,0001), then you get no more error message. If the arc length smaller, its generated a g1-line.I will test it this evening at the mach…
    in Host fails to connect to Windows Comment by jkret April 2022
  • I have also milled G2/G3 with CNC using Repetier.The following G-code with G2 does not generate an error, where is the difference?   Made using CamBam - http://www.cambam.co.uk )( Vogelhaus_V0.7 4/12/2022 9:33:24 PM )( Post processor: Default )( T0 …
    in Host fails to connect to Windows Comment by jkret April 2022
  • Thanks for the quick reply?Is there an interim solution until the next release?When will the next release be ready?
    in Host fails to connect to Windows Comment by jkret April 2022
  • I have a similar error message: System.NullReferenceException: Der Objektverweis wurde nicht auf eine Objektinstanz festgelegt.     bei RepetierHostExtender.basic.GCodeAnalyzer.arc(Single[] position, Single[] target, Single[] offset, Single radius, …
    in Host fails to connect to Windows Comment by jkret April 2022