jim8541
About
- Username
- jim8541
- Joined
- Visits
- 36
- Last Active
- Roles
- Member
Comments
-
This is my G32 result. I'm not sure what it is telling me. Does it seem right? My extruder height is 163.07 and G32 returns 163.340, should i change the Z height in the EEprom? Thanks, jim 00:18:31.493 : N114 G32*2800:18:31.493 : Z correction d…
-
Okay, how about running G29 for Average height then subtracting Z probe Z offset to get Z probe height?
-
If the Z probe height is the "distance between the nozzle tip and bed at the time the z probe switches to high" and I know the Z probe offset (the distance in mm between the Z probe and the Hot End, measured along the Z axis, basically up and down) …
-
Okay got it.Then what is Max_Z_Probe to Bed Dist.?
-
What does ZHold represent in that equation?
-
Yes, it's a E18-D80NK, DC-5V photoelectric
-
Hi, Yes M119 reports H when triggered and L if not triggered. I tried changing Pullup to false but it still does not stop when triggered. However, I used a voltmeter to check the output of the proximity detector. It outputs 3.5 volts when NOT trigg…