jgude
About
- Username
- jgude
- Joined
- Visits
- 9
- Last Active
- Roles
- Member
Comments
-
HAHA this was it! THANK YOU... no idea how this happened but who cares
-
latest from your website... i tried the manual way now too.. no result eiter...
-
supported=0 detected=0 something is wrong here
-
Hi I have the same issue. I had it working with a PI camera (used the pi preconfigured install), but it stopped working. I reinstalled the PI.. bought a new pi camera module... but nothing in the drop list. this is what i get when entering the above…
-
I probably screwed things up when updating the firmware... I went back to an older version and it worked again... so my bad sorry
-
I use core xy with radds/due board. But if first homing works all should be ok right? Home all works 1 time.. but home X and then y works only for x and it crashes in Y ...
-
I also go back 15mm after homing to untrigger the mechanical endstop
-
Yes manual trigger always gives the correct values. The problem is not during print.. allready when I hit home for a second time.. it will just ignore the endstop.. it worked fine but one of the hall-e endstops broke. I changed it with a mechanical …
-
I had this problem, but that was just because i did not add a extruder in the repetier server settings. once done it works perfectly. So the bug is that you can go into this screen without having a extruder set.
-
Worked! Thanks..
-
hi.. how do I get into the commandline? After boot I only have a server touch interface over hdmi available on a normal screen and my PI clone touch display is white. When installed rasphian I can use the touch screen but do nt get the touch interfa…
-
Ok..on two other pins it just works... some whining still but will power off when not moving.. Now getting that stallguard working...
-
Hi Guys, I finally have the time to update my printer. First problem is getting those Fytech TMC2130 drivers to work. I only have 2 for X and Y. Both only one works...it doesnt matter how i swap thing exept for the SPI connection 37 and 35..…
-
It would be really cool if i could use it as z max for my three z axis. As zmin i will use a piezo probe. As well for probing. No clue how i will do it at this point but ok .
-
Im very interested in your progres. I have a corexy based printer on radds+due+extension board..would like to replace the raps128 drivers with tmc2130 module... would it be possible to use the stallguard function to level the bed with the 3 z axis m…
-
Just used newer firmware... bed correction does something...will test if it does what it should do