javitopia
About
- Username
- javitopia
- Joined
- Visits
- 32
- Last Active
- Roles
- Member
Comments
-
So far no dry run issues encountered. I'm keeping my fingers crossed since i'm starting a 8h nylon print
-
OK, I'll also test (finally my printer is printing again!)
-
I'll check the next week when I hope to be back in painting. Also my cache move size is the default value wich I think it's 15, so should I decrease it any further?
-
Well my printer is still stopped, but i can check the free ram, wich is roperted to be 764 as soon as i connect. (Sidenote: should i do something about that? except for the dry run problem, i have no stability problems) And last, here is my current …
-
I'm using repetier host, and in one of the tests it also failed painting from SD card.
-
Does it happens at the same line every print? That's one of the things I want to test as soon I resume painting
-
The firmware will enter into dry run mode if one heater is marked as decoupled, wich could happen if wile running the temperature drops (or increases) 20 degree below set point. However in these cases the heater is marked as decoupled (it shows Dec …
-
Unfortunately, I'm upgrading some parts of my printer right now, so I have stopped testing. As soon as I have my printer back to business, I'll resume the testing with one of the problematic prints to check if the printer stops extruding in the same…
-
OK today happened again but enabling and disabling dry run from the host "solved" making the printer do a big extrude (arround 50mm) before continuing painting. I enabled and disabled dry run while the printer continued painting mid air. How can…
-
Normally I would say decoupled triggered, but then you would see dec in lcd display. I also do not think dry run got enabled? You could then try toggling dry run on/off to make sure or check in lcd debug menu. The last reason not to extrude would b…