› ›

jasper

About

Username
jasper
Joined
Visits
1
Last Active
Roles
Member

Comments

  • Correction:with the following setting the extruder stepper locks up#define EXT0_ENABLE_ON 0  With the following setting the extruder stepper does nothing.  Which is to be expected for the ramps board:#define EXT0_ENABLE_ON 1
    in The extruder motor doesn't work Comment by jasper December 2015
  • NOTE: when i send an extruder command from repetier, the extruder motor makes a small noise and locks up.
    in The extruder motor doesn't work Comment by jasper December 2015
  • I have the same problem: extruder motor wont turn.Dry run is offTemperature is 200 deg.motor, driver and board is fine - i re-installed marlin firmware and motor turns fine, re-install repetier firmware and motor wont turn.my extruder settings are b…
    in The extruder motor doesn't work Comment by jasper December 2015