› ›

jackcg

About

Username
jackcg
Joined
Visits
5
Last Active
Roles
Member

Comments

  • OK, thanks.  Does it mater where this define takes place?  I put it in Configuration.h and still got the same error.  Then I tried in BedLeveliing.cpp; Now I get "no matching function for call to 'RMath::max(float,float,long int, float)' 
    in Z probe to find bed level Comment by jackcg February 2019
  • Not sure if serial support was enabled on my linux machine, but think it was.  I looked in /dev/serial/by-id/ and found a device that I knew was connected, implying I guess that serial support is enabled.  But no 3D printer.  I'm kinda thinking that…
    in DaVinci 1.0A repetier firmware upgrade problems Comment by jackcg November 2018
  • No com port appears.  Tried removing xyzprinter software and reinstalling, but nothing changed, still doesn't recognize the printer.  Tried linux Mint, but lsusb didn't show the printer either.  Is it possible that I've fried the board during the re…
    in DaVinci 1.0A repetier firmware upgrade problems Comment by jackcg November 2018