› ›

ixlix

About

Username
ixlix
Joined
Visits
5
Last Active
Roles
Member

Comments

  • ziegelstein said: I did the conversion on radds / Due + Radds extension+ motorized bed leveling, z-Probe. Still questions? Do you have a config file i can see? I cant get mine working.
    in configuration.h for due/Radds Comment by ixlix August 2021
  • So i just measured the resistance of the silicone heater pad. Measring from the connectors on the leads its 321ohms. Being a 220V 800W heater pad that would make it that im only getting 160watts of power from it due to the resistance, hence the slow…
    in Very slow bed heating Comment by ixlix August 2021
  • Thanks for the info. When you say hardware error you mean the bed wiring or heater pad right? I swapped in the SSR from another working printer and the behaviour is the same, very slow heating. I just tried heating the bed to 100° and so far its be…
    in Very slow bed heating Comment by ixlix August 2021
  • I worked it out, the RADDS board needs 12v inputs at both sides two enable the 12v out to control the SSR. 
    in New mains bed install - RADDS not turning on SSR Comment by ixlix December 2019
  • Thanks for your suggestion. I've got it working now. I had to connect the due directly to the commputer and flash through Arduino. I doubled checked all the settings matched and had success. I do still find that ive reflashed a couple of times to ch…
    in I updated the Server and the firmware and now i cant get full connection Comment by ixlix September 2019