ikidd
About
- Username
- ikidd
- Joined
- Visits
- 2
- Last Active
- Roles
- Member
Comments
-
I pushed the commits to that PR, if you get a chance let me know what you think, but at this point I'm pretty perplexed why it isn't working on X but works on Y. I might try coding it on the Master branch as a test because there's some behaviour in …
-
OK, I've done another pull request with my somewhat working changes to the dual endstop code. As noted in the PR, Y is working properly, but for the life of me I can't see why X does not. If I swap pins so the axis are swapped in firmware, the prob…
-
I wondered about those defined stops, I couldn't find any places they were used but I didn't want to step on your toes if you had plans for them other than this particular purpose. Seems like this is the purpose you had in mind. Like an idiot, I d…
-
Well, I had that code copypasta worked up in a couple hours and then rigged my extra endstops yesterday morning. But I'm not getting what looks like independent sled motion and I'm really not sure why. I've added a Pull Request if you get some ti…
-
I'm going through and doing the XY versions to see if it's as trivial as it looks given the existing MULTI_ZENDSTOP_HOMING code I see there already. I'll post back if I have any questions.
-
Would I be able to easily adapt the Z code for X and Y, and if so, what would you quickly suggest I look at to get that done? I took a dev fork to look at but haven't gotten dirty yet, thought maybe there was already a built in option that wasn't d…