igli

Comments

• It is mechanical switch, so I connected it the wrong way? On what pin on board I must connect this switch to make it work? Please paste some pictures. Thanks

  in Z-probe and autoleveling on my mendelmax 1.5 need help Comment by igli January 2016
• Hello, Still got problem, I followed the instruction that are on RH site: Verify z-probeBefore you risk any damage, you should test, if you have configured the z-probe correctly. Run aG31to check the signal of the z-probe. It should be low/off. Now…

  in Z-probe and autoleveling on my mendelmax 1.5 need help Comment by igli November 2015
• Could you please point me to this commands for servo to operate. Thanks

  in Z-probe and autoleveling on my mendelmax 1.5 need help Comment by igli November 2015
• I replace the thermistor on motherboard, now heat's up properly. The next problem I've got it that the extruder temp goes to max 215 degrees celcius even if I set it to like 230-240.... Any ideas?

  in No temperature readings on smart LCD screen on Def Comment by igli January 2015
• Ok, I'll report tomorrow when i check it. Thanks for the answers! Regards

  in No temperature readings on smart LCD screen on Def Comment by igli December 2014
• It is very interesting if I put heated bed support out of the config the extruder works fine it's shows the correct temp and it is heating up!

  in No temperature readings on smart LCD screen on Def Comment by igli December 2014
• This is my configuration, I mesuered both thermistor, on the extruder is about 100k ohm and on the bed is about 7ohm. Thermistor on extruder is connected on T0 and the bed thermistor is on T1 connector on ramps. Here is my config: #define DRIVE_SYS…

  in No temperature readings on smart LCD screen on Def Comment by igli December 2014