hammertongs

Comments

• Great news! Turns out the wires running from the PowerSupply to the board were way too thin, despite being scavenged from a "standard" 3 prong CPU power cable.  The hot end was only able to pull about 8.9v.  I swapped them out with properly gauged w…

  in Hot End fails to reach temp during print job, but works fine manually Comment by hammertongs December 2016
• Ok, after ensuring my firmware was configured correctly, and the Fan headers were set correctly, the fan now comes on at 50C like I have configured. In addition, I have also run the PID auto-tune, and used it's values in my Configuration.h.  It hold…

  in Hot End fails to reach temp during print job, but works fine manually Comment by hammertongs December 2016