› ›

gschulz

About

Username
gschulz
Joined
Visits
0
Last Active
Roles
Member

Comments

  • Thanks again.  Unfortunately, 2560 isn't footprint compatible with the 1284, so I can't swap it out.  I'll look closer at the V1 solution.
    in Z offset added to X Comment by gschulz September 2018
  • Thanks for the feedback.  You pointed me in the right direction.  My controller is similar to a Melzi running an ATMEGA1284.  As long as the code fits in 128KB, it should be fine.  This gives me hope that this firmware will be the ideal choice for m…
    in Z offset added to X Comment by gschulz September 2018