georgeli
About
- Username
- georgeli
- Joined
- Visits
- 1
- Last Active
- Roles
- Member
Comments
-
Repetier said: That link is our plain github repository. It contains the firmware in all versions published but no configurations for the printer you have. So you would at least require a configuration.h from zego to do so. But I'm sure it do…
-
Repetier said: Sure you can install a new firmware with the Arduino IDE. From your question I assume you bought a assembled printer with preinstalled firmware? Ask your vendor for the sources so you see the settings. Without this it is hard t…
-
Repetier said: How did you print with slower speed? Did you reduce z max speed? I don't think xy speed for printing which you set in slicers matters here and for z some slicers rely on firmware reducing speed to a healthy limit. The code does…
-
Repetier said: How did you print the good one? I can only think of 2 reasons.1. Spindle has some error at that height2. You are loosing steps at that height (friction?) so layer switches are not as high as steps would suggest. Slower accelera…