› ›

gdville

How can I recover my Pro version license code? SD card in my RPi/Repetier Server died, so had to reinstall. Can't seem to find an email containing the license...

About

Username
gdville
Joined
Visits
4
Last Active
Roles
Member

Comments

  • RAyWB said: DRV 8825 should have#define STEPPER_HIGH_DELAY 1also as repetier mentioned:What is strange is #define X_ENABLE_ON 1 #define Y_ENABLE_ON 0 #define Z_ENABLE_ON 1usually the DRV8825 should all have 0 to get enabled Changed STEP…
    in motors just vibrate Comment by gdville December 2021
  • What is strange is #define X_ENABLE_ON 1 #define Y_ENABLE_ON 0 #define Z_ENABLE_ON 1 This setting is driver dependent so it means y axis uses different driver.This was an experiment to see if a) one would work- none did , and b) if anyone would catc…
    in motors just vibrate Comment by gdville December 2021
  • Buzzing should indicate that is ok as you loose steps on moves. Check eeprom settings - maybe you have there invalid or too high values - config only replaces them on different EEPROM_VALUE. Otherwise use M502 M500 to copy them to eeprom so config v…
    in motors just vibrate Comment by gdville December 2021
  • Repetier said: Does printer start with motors disabled or does disabling motor gcode disable them s you can move them freely? This is to check if enable signal is defined correctly. I have tried both ways. 
    in motors just vibrate Comment by gdville December 2021
  • I've got similar problem. Rumba+ board, DRV8825 step drivers, no motion control. This board has previously worked with same drivers, but recently reflashed it with RF to replace burnt out controller in my delta. Have also tried A4988 drivers from pr…
    in All motors energized but not moving at all Comment by gdville December 2021
  • I have similar problem, using Rumba+ board and DRV8825 step drivers on my delta. I previously had this board and drivers working with different firmware, so am relatively certain the problem is not hardware. I've also temporarily swapped out the dri…
    in motors just vibrate Comment by gdville December 2021
  • SSH was over wlan as well.  After an update and a couple more reboots, it seems to have resolved. I believe the PID was changing, but it's no longer having the problem, so can't confirm. This is an older RPi / R-S build I've been using successfully …
    in Latest version 0.94 keeps loosing wired connection Comment by gdville June 2020
  • Just upgraded to 0.94.1. Dark mode looks awesome BTW. Similar issue, wireless connection.  Sometimes I get 502 Bad Gateway error, but can connect via SSH and when I do a sudo reboot, sometimes I can then get in through browser or Repetier-Host, but…
    in Latest version 0.94 keeps loosing wired connection Comment by gdville June 2020