› ›

frans87

About

Username
frans87
Joined
Visits
7
Last Active
Roles
Member

Comments

  • It's a RAMPS 1.4 so, according to the scematic, yes, pin 18 is Z-min. I'll give 1.0.4 another try a bit later (when back from work...) with the same change as above. Anyway, thanks alot for your help so far !
    in x-y offset of print due to z-probe offset Comment by frans87 June 2020
  • I have switched back to 0.92.9 (also because SD card did not work anymore with 1.0.4) with the following change, it now works OK ! I switched to Z_PROBE_Z_OFFSET_MODE 1 with Z_PROBE_Z_OFFSET 0 (probe measures coating level) before I had Z_PROBE_Z…
    in x-y offset of print due to z-probe offset Comment by frans87 June 2020
  • Tank you for you answer. I have updated to 1.0.4 but now my z-probe does not work any more. Start script for servo is not executed. I get no error message on screen, nor on Repetier host. The sevro and probe  work on G30 though... I have tried setti…
    in x-y offset of print due to z-probe offset Comment by frans87 June 2020
  • UPDATE Auto level works again !! I started again from a fresh install, and auto level work with Hardware Z min enabled. Is that OK ? Frans
    in Auto bed leveling does not update z-height Comment by frans87 February 2015
  • Hello again, I've tried to get it right but it's getting worse ! Switching software z-probe true or false does not help. I have now installed the 92.2 version firmware. Now z-probing does not work at all. All settings, as far as i've been able t…
    in Auto bed leveling does not update z-height Comment by frans87 February 2015
  • Hi, again, I've yust checked one other thing : The Z-min SOFTWARE endstop is disabled in the firmware. Could this be the cause ? Also in printer settings (Host) i've set Z max end stop. I can't test it for now, i'm not at home... Cheers Frans87 
    in Auto bed leveling does not update z-height Comment by frans87 February 2015
  • Thanks for your help, i'm printing right now ! I realised my extruder was not performing well. I made an other hobbed bolt my self and it extrudes well now. I bought a kit, and i must say, i had to change a lot of things to make it a working machi…
    in Motor only moves in one direction Comment by frans87 January 2015
  • OK, thanks for your answer. So just to see if i understand well : My settings in FW are : Feedrate : 50 Start feedrate : 20 Accelleration : 5000 Nozzle : E3D-V6 0.4mm ABS 3mm Those were the default settings in the FW wich i didn't touch. Now, …
    in Motor only moves in one direction Comment by frans87 January 2015
  • Excuse me for the multiple posts, i've discovered something new : In repetier host, the "bad" direction = retraction, is much faster than the extrusion speed. I can retract if i lower the feedrate setting to about 35, It doesn't work with the defau…
    in Motor only moves in one direction Comment by frans87 January 2015
  • UPDATE : I can move the extruder motor just fine in both directions with the LCD command , even when extruder is cold ! In repetier host the same problem persists, so might be a problem between UI settings and FW ? I tried to post configuration.h …
    in Motor only moves in one direction Comment by frans87 January 2015