firesped
About
- Username
- firesped
- Joined
- Visits
- 13
- Last Active
- Roles
- Member
Comments
-
I have wiring issues on the printer
-
my timeout is set to 30 seconds, going to try increasing this to see if I can get past the issue.
-
here is the gcode for that layer up until the failure. 2:53:18.438: M117 Layer 2/373 2:53:18.438: N182 M105 2:53:18.440: ok T:205.9 /203.0 @0 B:60.2 /60.0 @75 2:53:18.440: N183 M105 2:53:18.883: ok 2:53:18.883: N184 G1 X79.166 Y44.155 E17.5685 2:5…
-
I figured out what happened. when I upgraded Jessie, it did not reinstall lightdm. I executed "sudo apt-get install lightdm" then in raspi-config, I boot option to mode 4, auto login to PI and start X windows. It is now working correctly.
-
I updated my Pi 3 to the latest repetier server. 0.85.2. I had to do it manually. In the process I also upgraded the Pi 3's Jessie as I have the camera module for the Pi installed and it was not working. Now the touchscreen is not working with serv…
-
installing the rasberry pi image now onto the SD card. also making a backup of the file system to my harddrive from raise3d touchscreen
-
I did pickup a pi to set this up on as well. I have a monoprice maker select v2 running repetier, so a repetier-server to run that verses my octopi seems like a better option.
-
found my distro. root@imx6qdlsolo:/# cat /etc/issuePoky (Yocto Project Reference Distro) 1.7 \n \l
-
trying to figure out what version I need to grab right now. root@imx6qdlsolo:~# archarmv7l root@imx6qdlsolo:~# uname -aLinux imx6qdlsolo 3.10.53 #72 SMP PREEMPT Sun Sep 6 16:25:47 CST 2015 armv7l GNU/Linux root@imx6qdlsolo:~# free total…
-
we have instructions on how to kill their GUI, that is how we run octoprint. I'm interested in setting this up.
-
first to estabilsh, i dont work for raise3d. the printer has a 7 inch capasitive touchscreen with a imx6, quad 1ghz ARM processor. the touchscreen has ethernet and wireless. it runs a ui by raise3d that is closed source but they have shared the firm…