› ›

ff419

About

Username
ff419
Joined
Visits
4
Last Active
Roles
Member

Comments

  • How would I go about taking advantage of this change?
    in Double coordinate for extruder in host Comment by ff419 April 2017
  • Sorry, I wasn't at the computer when I sent that reply. If this isn't the right log info please let me know. It apprears that in this log on the last command it's returning the right info, but in the host it would display Z at 40 08:07:14.616 : Prin…
    in Double coordinate for extruder in host Comment by ff419 April 2017
  • Thanks for the quick response. You are right... It is a bit different now that I check, but this was the closest I could find. I am in CNC mode in printer settings. What I'm trying to do is touch off a Z-probe then use a G92 code to set the Z axis …
    in Double coordinate for extruder in host Comment by ff419 April 2017
  • Hi, I'm running into this same issue. I have a MPCNC with a Ramps 1.4 board flashed with the Marlin RC8 firmware. Running the host 1.6.2 on windows. The problem is identical to what Kina was saying. A G92 command shows as double in the host but norm…
    in Double coordinate for extruder in host Comment by ff419 April 2017