etaoinsh

About

Username: etaoinsh
Joined: March 2021
Visits: 1
Last Active: March 2021
Roles: Member

Comments

BTW, this is on an Ender 5 Pro.

in Issue connecting my Delta 1315 Comment by etaoinsh March 2021
Repetier said: You are only connected to port but no communication. (is ack enabled to be shown?). You see we send commands but no firmware response. Typical reasons: - Protocol not automatic - Wrong baud rate - A few boards need special RTS/…

in Issue connecting my Delta 1315 Comment by etaoinsh March 2021