ebuyum
About
- Username
- ebuyum
- Joined
- Visits
- 4
- Last Active
- Roles
- Member
Comments
-
I've just tried with version 1.0.2 after disabling almost everything. The configuration file can be found here: https://pastebin.com/ayJaC7Jk However, the same behavior can be observed as before when homing Z (no bed leveling actions taken yet). …
-
I tried that as well but am unable to use it since the firmware ends up being too large.
-
Thanks for the reply! I forget to mention that in one of my previous attempts, I tried setting z_probr_height to 0, that did not help however. I'll try the other suggested settings a bit later, but I still don't understand why they cause t…
-
Thank you for the inputs. It turns out that the IO pin on the sensor's connector was a bit loose (middle pin), causing intermittent disconnections to the board. After replacing the connector everything seems to be working well, updating here for p…
-
Now I'm having a different issue however, it seems that the zstop isn't triggering. I'm not sure if this is a sensor issue or not, the stop used is an inductive proximity sensor TRZ-Pl-08N (http://www.fotek.com.tw/pdf/etc_227.pdf), the LED on the s…
-
Well, I'm not sure why but replugging everything seems to have solved the issue! the printer now boots fine and I can connect to it via the repetier host software (I could connect to it in the past but it just rebooted all of the time). I'm wonderi…
-
Hello everyone, Another victim of a weird printer here, I seems to be plagued with all of the issues listed here. However, it seems that no matter what I try, I can't seem to get the printer to work, I updated the bootloader, and have tried flashi…