› ›

dnaman

About

Username
dnaman
Joined
Visits
1
Last Active
Roles
Member

Comments

  • Even further to this, I found the problem: First I tried the Cura slicer in place of Slic3r and it gave me sensible filament requirements in "Printing Statistics" so it appeared that the problem was Slic3r related. After much digging, poking and dr…
    in No filament feed Comment by dnaman July 2018
  • Further to this: - There are no A-moves and no E-moves in the gcode. - The firmware is version 0.92.10M Don't know if that's enough to identify the firmware flavour or not. I wouldn't, wittingly, have chosen a Mach3 flavour except on a best-of-a-b…
    in No filament feed Comment by dnaman July 2018
  • Well, as I said above (in my stumbling fashion), the gcode doesn't contain any E-moves. I didn't (but will) check for A-moves - didn't realise that possibility - nonetheless, the "Printing Statistics" show 0mm filament needed which suggests the slic…
    in No filament feed Comment by dnaman July 2018