dmkmedia
About
- Username
- dmkmedia
- Joined
- Visits
- 56
- Last Active
- Roles
- Member
Comments
-
I can heat the hot ends up but the temp starts at -22 if i leave it it will rise to 200 but the bed is showing 33 degrees and wont move from there no matter how hot it gets so i know its not ideal i have to turn the hotbed on manually then turn it o…
-
no matter what value i put in there it still tests 3 points 2 at the front one at the back in the middle
-
cant see the 4 point or mor bit
-
im not sure what i did but its now working
-
i have now got my hot end to heat up but now the extruder will not feed and alsoi have had to disable my heated bed for now as I cant get that to detect a temp it will heat up but the thermistor is not detecting any heat
-
i was sent this link https://wiki.e3d-online.com/wiki/E3D-v6_Assembly#Configure_Firmware_.28Easy.21.29
-
i give up i can not get this MPX3 board to work.since i have bought this sainsmart.com board THC_RAMPS_3D V1is there a board selection that will work in the firmware config. i might have a better chance with this board
-
even if a select the thermistor recomended by E3d i am showing a temp of -12 at the mo using the dev vesion
-
i have not had a stable working on this. I just thought once i upgraded to the new E3d stuff I could use the firmware as I could never get it working with the old set up I can get the bed heating up at the mo but I can not get the thermistor detect…
-
yes, everything has been changed apart from the x-axis y-axis and heated bed.but honestly, I have not a clue what settings to make, to make this right dont know weatehr i should be on here or calling e3d to help me
-
so how can this be fixed?as i said i have only changed the extruders and hot ends i have also bought a new 3d printer board just in case but its a different make not sure if it's better its a sainsmart THC_RAMPS _3D V1
-
i will show him i know the person
-
any idea where ther language folder is i used the image install
-
that was it thanks
-
i have changed the speed down to 4mms but still get the noise on homeing only
-
where are you on about ?
-
ok after a few days i found the correct marlin firmware and got it working. but now you al have me thinking.... about yourfirmware and it uploaded and X & Y Seem fine at 80mms but the z moves very slowly I uploaded the Repetier firmware to a hic…
-
i mean if it is meant to move up .4mm it seems to move up double that and the layers dont make contact