digibluh
About
- Username
- digibluh
- Joined
- Visits
- 9
- Last Active
- Roles
- Member
Comments
-
So the MK3 uses this now, so i suppose it works well.
-
Yes, even for homing moves it seems too. i just see it happening on travel moves, which are probably one single command when moving across the print. i think accel is 1500 and it's currently at 80mm/s in the slicer for travel moves. what's the…
-
well, fuck that. g33 is completely messed up, has no coordinate reset on error, no bounds checking, nothing... not only has it driven the extruder into the bed twice so far damaging my coating, and screwed up the z-probe, it's damaged my X axis thi…
-
k, will give it a shot.
-
Hey, Thanks for the reply. i assume as much, there is some bumps so to speak though this is my last probe result.... i raised to 10mm before starting since it can't drop the probe otherwise. but one side of the bed it's 13 and the other drops to …
-
nevermind, re-did everything from scratch, seems good.
-
This isn't working for me, it does nothing. it's set to XY preheat Z, etc... Z probe enabled etc.... Probe works and all with the usual commands but regardless the settings, on homing it never raises Z, never triggers probe start, it just starts …
-
Not a corexy issue or specific to any type of printer. they'll all do it, except maybe a delta... though i don't know but i saw it on every other type regardless in one form or another. This seems far from determined, in some cases it's low cu…