dbrown31

Comments

• What really physically is happening is the nozzle is being moved up in Z after the skirt and outer perimeter have been printed and then after about 3mm of print model flattens out and layers are proper. To me if the autolevel data was wrong then it …

  in First Layer, Z Retraction Height set to 0, Perimeter clean, Infill beaded Comment by dbrown31 January 2016
• This solved the issue described directly above...#define ENDSTOP_Z_BACK_ON_HOME 10 Thanks!

  in Z Probing, Understanding Max Z-probe -bed distance Comment by dbrown31 January 2016
• Appears, after updating to the newer firmware things are much closer.  When performing G32 S2 (9 point 3x3 grid) the light on the inductive sensor is only triggering at some spots, which I would presume is not providing the most accurate plane.  Z p…

  in Z Probing, Understanding Max Z-probe -bed distance Comment by dbrown31 January 2016
• Thanks for the explanation.  Your dedicated support is much appreciated!!! Have been struggling since downloading repetier firmware 12-27-2015 (just saw tonight that you released an update about firmware on 1-3-2016 regarding bed correction method).…

  in Z Probing, Understanding Max Z-probe -bed distance Comment by dbrown31 January 2016
• Did not close the host.  It appears if extruder is not up to temp it retracts after it has been brought to temp with my M104 S235.

  in Skeinforge, Repetier Firmware and Host, Initial Retract of approx 50mm Comment by dbrown31 January 2016
• THANK YOU REPETIER!!! My solution appears to have been setting Z_PROBE_ON_HIGH to 1 or true. Thanks so much!!!

  in Z probing, Homing ok, Not editing Transformation Matrix, Marlin to Repetier Comment by dbrown31 December 2015