daniro

Comments

• Z 100 IN SOFTWARE IS Z100 IN REALTY, WHEN I PRINT I NOTICES THERE IS 2 mm offset for some reason from the value that is shown to acctual value., for example 4 is 6, etc. and it isn't the z offset value, becuase it is set to -0.5. any ideas?

  in AFTER FIRST LAYER PRINTS IN AIR Comment by daniro January 2017
• Where is the Z control. The slic3r generates the code. And there movments in Z by layer hight i geuss

  in AFTER FIRST LAYER PRINTS IN AIR Comment by daniro January 2017
• control board SANUINOLOLU 4A4998

  in Z AXIS TRAVEL DISTANCE IS DIFFERENT BETWEEN SOFTWARE AND ACTUAL WORLD Comment by daniro January 2017
• solved, changed the steps of z to 426.67.

  in Z AXIS TRAVEL DISTANCE IS DIFFERENT BETWEEN SOFTWARE AND ACTUAL WORLD Comment by daniro January 2017
• M8 THREADED RODS, DEFUALT STEPS ARE 2560 STEPS/mm

  in Z AXIS TRAVEL DISTANCE IS DIFFERENT BETWEEN SOFTWARE AND ACTUAL WORLD Comment by daniro January 2017