daniel
About
- Username
- daniel
- Joined
- Visits
- 15
- Last Active
- Roles
- Member
Comments
-
Success!!! it's running! It was all about the cable length! At least the Text Display. The cables must not be longer than 20 cm to get somthing displayed! So Due+Radds+20x4 Textdisplay is working A few minutes ago I tried cabeling the Full Graphi…
-
The LCD Project had to wait a littlebit, but i used the time to change my K8200 mechanics to CoreXY, replaced the controller with the DUE and the RADDS and changed X+Y stepperdrivers to 1/128 ones. Till now everything works nearly great - only some …
-
Sorry for the late reply. Due to too much work, I had no time to try any further. But I have found a possible reason for the LCD not showing anything. I've read a datasheet for a similar LCD and there is 0,7*VDD mentioned as minimal H Level for the …
-
ok thanks, i will try this tomorrow
-
Ok, the content of u8glib_ex goes far beyond my programming skills... I will try to get the Display running with Marlin oder directly with the u8glib... but only for testing - my goal is it to get repetier running with this display
-
u8glib could be the point. i've found out that i have Version 1.11 installed, but version 1.17 is available... i will try to update and test again
-
Thanks for your reply yes, on the Mega 1280 I successfully tested it with repetier. I told the configurator it would be an Mega1280 with Ramps 1.3 and wired it by hand. I was able to navigate through the menus. I compared the uiconfig.h from the m…
-
Hi, currently I have an K8200/3drag with the original board and Marlin. But I'm planning to switch over to an Arduino Due with the Radds Board, the Repetier Firmware and 1/128 Stepperdrivers in X/Y. Additionally I wan't to connect this Display: http…