crussty

Comments

• I am just looking at getting the BLTouch working on Repetier.  Is this hack still required, and has it been tested and proven to work?  Many thanks!

  in BLTouch Comment by crussty June 2016
• Brilliant! I've been stuck in Marlin land too long to have even considered that! Just browsing the HAL.cpp rom the iPad, I believe I've found the two places I need to invert. I must say, the code is very clean!

  in Enhanced Heat bed options Comment by crussty May 2016
• That is a good option. Thank you for the suggestion!

  in Z Probe as Z Min Limit - Mimic Marlin - Safe Z Homing Comment by crussty May 2016
• Thank you. I will look in HAL.cpp. Open to any ideas on multi-zone heater support and happy to help test if needed to get it online.

  in Enhanced Heat bed options Comment by crussty May 2016
• I am running fine by defining both the Z Min pins for my probe and Z-min end-stop, however, I'd like to second this request for safe homing.  Or at the very least be able to define an X/Y location that Z homing should occur.  I.e. Home X, Home Y, Mo…

  in Z Probe as Z Min Limit - Mimic Marlin - Safe Z Homing Comment by crussty May 2016