cradi
About
- Username
- cradi
- Joined
- Visits
- 25
- Last Active
- Roles
- Member
Comments
-
Hello, ok many thanks, now i get it run. auto leveling is now korrekt. There was a wrong value in the eeprom for Z_Probe_High. Next step is Distortion_Correction in your Video.G29 measure only three points and give a average height. In the video it …
-
Hello,please have a look at my configuration.h https://dl.dropboxusercontent.com/u/28536763/Configuration.h An here is the log from my calibration. I do the same steps as in your video shown. < 07:19:56: FIRMWARE_NAME:Repetier_0.92.9 FIRMWARE_UR…
-
sorry, my Firmware Version is the actual Version 0.92.9 Is it helpful to use the dev Version?
-
i must add some Informations: I use an Z-Probing with FSR Sensors. So i have no Distance between Nozzle an Sensor.