codebuster
About
- Username
- codebuster
- Joined
- Visits
- 5
- Last Active
- Roles
- Member
Comments
-
The new changes are good. Thank you. The piezo probe is working as expected.
-
Great. I'll be watching the commits and will test the dev branch as soon as I see your changes.
-
At one point I had the delay up to 1000. This merely delayed the beginning of the probe cycle. I currently have it at 500, but it appears to not effect the second probe timing. I am aware you added this setting purely for the purposes of piezoelect…
-
I am using Repetier 1.0.2 which does have endstop debugging mode. I changed the firmware to enable pullup, Z probe on high, and Z min inverting. It reported during G30 P0 that when I tapped, Z probe was H. It then gave me "untriggered" error; after …
-
The Piezo20 works by pulling SIG down to 0V once it detects a voltage spike from the piezo element compression. The piezo element, once compressed, does not produce continuous voltage. it's only a pulse. Also, the Piezo20 board doesn't provide its o…