cncdrifter
About
- Username
- cncdrifter
- Joined
- Visits
- 3
- Last Active
- Roles
- Member
Comments
-
What is your print area 200 mm You use there a #define MIN_HARDWARE_ENDSTOP_X true and #define max_software_endstop_x true (at 275mm / #define X_MAX_LENGTH 275) Also have a look on Y the max is 163mm and distortion max upto 190mm
-
By manual editing i give them the same sensor, but in manual mode all three extruders run the same speed I will have a look later how with the configuration tool, without mixing extruder selected, if mixing extruder is selected there is no option …
-
The physically the third, fourth and fifth are expanders from aux1 and 2 I use stepper Motor v1.1 boards (E/S/D; D44/D64/D59; D44/D64/D59 , D58/D57/D1 declared in Pins.h). Shared extruder was only to trying to get an configuration.h with one tem…