cinpro

Comments

• and a new development, Z home up instead of down, whether I invert the homing direction or not

  in BL Touch congif help needed Comment by cinpro March 2017
• #define Z_PROBE_Z_OFFSET 0 #define Z_PROBE_Z_OFFSET_MODE 0 #define UI_BED_COATING 0 #define FEATURE_Z_PROBE 1 #define EXTRUDER_IS_Z_PROBE 0 #define Z_PROBE_BED_DISTANCE 10 #define Z_PROBE_PIN ORIG_Z_MIN_PIN #define Z_PROBE_PULLUP 0 #define Z_PROBE_O…

  in BL Touch congif help needed Comment by cinpro March 2017
• If FEATURES RETRACTION is enabled the retraction settings from the slicer is ignored? Just want ro see if I'm following you.

  in FEATURE_RETRACTION & AUTORETRACT_ENABLED Comment by cinpro February 2017
• MartinH said: With the extruder, the only reasons i can think of is that steps/mm are set to 0, or in repetier host (if that is what you are using,make sure 'dry run' is not enabled that turned out to be the stepper drive being turned do…

  in Extruder and Z not working properly Comment by cinpro February 2017
• I changed the EEPROM from 1 to 2 but motorsports through g-code at an earlier stage and it didn't work as expected.

  in not all settings downloaded Comment by cinpro February 2017