bryanbdp
About
- Username
- bryanbdp
- Joined
- Visits
- 8
- Last Active
- Roles
- Member
Comments
-
I just read their printing guide closely. It does state that the sensor detects motion in addition to outage. Would definitely like to be able to use it with Repetier!
-
Now that you mention it, I think you're right. The Prusa is supposed to detect filament slow downs and jams, but I think that is a function of the stepper motor drivers, not the filament sensor as I assumed...
-
What determines which is which? Is it one of the pin numbers assigned to drive a given stepper controller? Is the number the same as the ones in the pins.h in the firmware?
-
Anyone?
-
I thought there was a way to pull the Mega pin low, then trigger with a high signal... However, I don't even know where to begin to find the code that controls this, I don't think it's set up to be changed easily. Thanks, Bryan