blastactionhero
About
- Username
- blastactionhero
- Joined
- Visits
- 2
- Last Active
- Roles
- Member
Comments
-
i have had allready set the FEATURE_FAN_CONTROL to false 0 /** Should support for fan control be compiled in. If you enable this make sure the FAN pin is not the same as for your second extruder. RAMPS e.g. has FAN_PIN in 9 which is also used …
-
Hello, thats my opinion, too. I have had checked the pin settings. I think, pins.h are the heaterpin connected like on the hardware should be. #define HEATER_0_PIN 10 // 1. extuder on D10 #define HEATER_1_PIN 9 // 2. extrud…
-
Hello, I have a protos v2 with a repetier firmware. I want to update my printer to a dual extrusion. I can turn on the second extruder over simplify3d. The second extruder heat very slowly. And to my astonishment, the heatbed heats uncontrolled up…
-
Many Thanks!!
-
i had set in the configuration.h the line " //#define FAN_PIN 4 // Extruder 2 uses the default fan output, so move to an other pin" as" #define FAN_PIN 4 // Extruder 2 uses the default fan output, so move to an other pin" could you please hel…
-
hello, how i set it to a differnt pin or how i could disable the fan feature? i had set in the configuration.h the line " //#define FAN_PIN 4 // Extruder 2 uses the default fan output, so move to an other pin" as" #define FAN_PIN 4 // Extrud…
-
hello, how i make sure that the fan use a different pin or how i could disable the fan usage? best regards