bionicrocky
About
- Username
- bionicrocky
- Joined
- Visits
- 1
- Last Active
- Roles
- Member
Comments
-
I'm concerned that I had been making changes to the configuration.h in the Arduino IDE, uploading them, then rebooting. Were the changes I had made lost if I didn't issue the M500, M502? It would explain a lot if so. It also sounds like I w…
-
This is good to know. So after I upload to the Arduino, should I be issuing those commands? I may have been missing that step. My x-axis stepper driver fried, so waiting on a new one to arrive Wednesday.
-
MartinH said: In your config,you have #define ZAXIS_STEPS_PER_MM 100 100 seems very low, normally for 1/16 microsteping (3 jumpers fitted under each driver pcb) for M5 threaded rods on Z it would be 1600 for M8 4 start lead screws it would …
-
Also, I'm quite happy reading the documentation, I just don't know where to look in it or where to find the parameters for my printer. I had hoped that since it's fairly common someone might know the settings. Any particular documents you would…
-
Ok, I'm sorry, like I said I'm brand new to this and was only able to flash the firmware because I've worked with Arduino. Where can I find a step by step to do this and how to calculate the values that are needed?