› ›

bikerjim500

About

Username
bikerjim500
Joined
Visits
17
Last Active
Roles
Member

Comments

  • I cannot figure this out without some idea of what I am doing here.  Here is the dump from my eeprom AGain, when I see things like Floor saftey margin and have no idea how to calculate that, or Max Horz Radius, Should I extrapolate corners? What cri…
    in z Leveling Comment by bikerjim500 October 2015
  • It sure would be nice to know the current firmware settings in there, especially as I read more, because things like the thermister type etc etc - I do not know, my printer came mostly assembled (%95) when I got it.
    in what firmware do I have Comment by bikerjim500 September 2015
  • Hey - how about that !   Thanks ! I suppose there is no way to find out what settings were in that once loaded.  ?  I'm thinking not since I just read (somewhere) that I can't.  That would be to easy I guess.  Now I am thinking if that is true and …
    in what firmware do I have Comment by bikerjim500 September 2015
  • P.S.  It says "KOSSEL MINI READY " On the bottom of the printers display. The display begins wiht top; temp next; X Y Z next; a funny sybol , a %100 SD_____% 0--:__ and then the ready blurb.
    in what firmware do I have Comment by bikerjim500 September 2015