balbotizy

About

Username
balbotizy
Joined
Visits
9
Last Active
Roles
Member

Comments

  • I understand the value
  • Is not possible have to a scale 0 5v to 0-255?
  • Sorry, buti in this case i have 200 5v ? I need a pwm effect, to scale 0-5v in 0-255 for command ttl laser power I understand that this modify is ok Thanks
  • Sorry but is not possible to insert into the fim the m42 value pwm (s0 5v s255 5v) in pin 4 servo for command a driver ttl ? is this difficult feature, because is not use a ttl laser driver with repetier firm but i can t use marlin firm. Help me ple…
  • http://mindndream.tistory.com/category/Arduino Is possible to modify repeiter in this mode?
  • ok thanks a lot for information, but now i have a ttl 5v laser control, where i connect the ttl input and that gcode use for use the laser? Tiziano
  • Hello is possible to limit a voltage in firm section at the fan connector or in hot bed 2 (5v)?
  • Sorry the ttl is a 5v and i use a pin 11 pwm servo. In this solution you control the poeer of laser in black 255 white 0 and a gray scale
  • Menu for laser section for me ideamy laser into the gcode change the power whit a pwm not for speed
  • My laser is ttl version and i use a pwm pin 11 (servo) with m42 gcode command.is possible use the laser to active the servo mode and not a laser section ?I am confusion for different a laser slection or servo mode in firm Thanks