badvision
About
- Username
- badvision
- Joined
- Visits
- 0
- Last Active
- Roles
- Member
Comments
-
Confirmed working now. I re-enabled the eeprom mode (mode 1) and disabled host rescue. No issues anymore, and no weird negative numbers showing on the display either for any axis or extruder. I think restoring values should follow a boundary chec…
-
I will try it. Also I'm not running a host so I could also try disabling host rescue also, right?
-
I tried EEPROM Mode 2, no luck. Same issue. Disabling EEPROM mode resolves the issue, except now I can't load settings from EEPROM.
-
Update: After a cold start I went directly to Reset EEPROM. Homing issue was not reproduced but still seeing weird numbers for axis positions before homing, and E position is weird. Performed another cold start without resetting EEPROM and issue…
-
In case it helps here's the configuration.h file: /* This file is part of Repetier-Firmware. Repetier-Firmware is free software: you can redistribute it and/or modify it under the terms of the GNU General Public License as published by …