› ›

badman

About

Username
badman
Joined
Visits
5
Last Active
Roles
Member

Comments

  • Hi! Thanks for supporting in this matter. I'm using a mega 2560 with ramps on cartesian printer. Think i found the problem, i DID assign the pin in configurator AND i DID asign ramps 1.4, BUT, now when i look in the config, it's melzi board thats ch…
    in Z_MAX_PIN Comment by badman November 2016
  • Maybe a voltage dvider could be some help for you? Not an elcrtipro my self but have used V-Dividers some times. just need two resistiors at the right values and because the fans don't take much current there should not be any heat probs or burnt re…
    in Two 5v fans under RAMPS 1.4 - D9 exit Comment by badman September 2016