azz00
About
- Username
- azz00
- Joined
- Visits
- 14
- Last Active
- Roles
- Member
Comments
-
That's worked perfectly. Thanks again. In regards to the axis compensation, I have enabled both the z probe and the compensation in the features menu. Is there anything else I need to do? At the minute I have a print that comes out at 88 degrees a…
-
Hi Repetier, An update for you, I found the following website and followed what it said. Turns out it was something to do with the drivers?!? Anyway thanks for the help you provided. http://modlr.blogspot.co.uk/2013/05/marlin-on-gen6d-part-2.html …
-
Hi Repetier, Thanks for getting back so quickly. When I go to upload the firmware it says "Binary sketch size: 54,270 bytes (of a 63,488 byte maximum)" I did think that there wasnt much space so I turned alot of the features off