atratra

About

Username: atratra
Joined: February 2015
Visits: 10
Last Active: April 2015
Roles: Member

Comments

Ok, my fault, was an eeprom problem...

in Low Z stepper resolution ignored Comment by atratra March 2015
Sorry, revised post... Hi, I have a problem with Z stepper resolution. I've installed two tr8*8 leadscrews 4 starts instead of the preceding m5 screws on the z axis of my prusa i3 and with marlin firmware there are no problems. If I set the correct …

in Low Z stepper resolution ignored Comment by atratra February 2015